HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use the following procedure to troubleshoot the parking assist monitor system.
- *: Use the GTS.
- Use the following procedure to troubleshoot the parking assist monitor system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
Measure the battery voltage with the engine switch off.
- Standard voltage:
- 11 to 14 V
| |||||
| 3.CHECK NAVIGATION SYSTEM OR AUDIO AND VISUAL SYSTEM |
Refer to the navigation system (for Navigation Receiver Type) (Click here).
Refer to the audio and visual system (for Radio and Display Type) (Click here)
Result Result
Proceed to
Navigation system and audio and visual system are normal
A
Navigation system is abnormal
B
Audio and visual system is abnormal
C
|
|||||
|
|||||
| |||||
| 4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the GTS to check if the CAN communication system is functioning normally.
- for LHD with Entry and Start System: Click here
- for LHD without Entry and Start System: Click here
- for RHD with Entry and Start System: Click here
- for RHD without Entry and Start System: Click here
Result Result
Proceed to
CAN DTC is not output
A
CAN DTC is output (for LHD with Entry and Start System)
B
CAN DTC is output (for LHD without Entry and Start System)
C
CAN DTC is output (for RHD with Entry and Start System)
D
CAN DTC is output (for RHD without Entry and Start System)
E
- for LHD with Entry and Start System: Click here
|
|||||
|
|||||
|
|||||
|
|||||
| |||||
| 5.CHECK FOR DTC* |
Check for DTCs and note any codes that are output (Click here).
Clear the DTC (Click here).
Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
- NOTICE:
- The parking assist ECU may store the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the parking assist monitor system are output, refer to Diagnostic Trouble Code Chart for the applicable system.
System
Proceed to
Side Monitor System
Click here
Wide View Front Monitor System
Click here
Result Result
Proceed to
DTC is not output
A
DTC is output
B
|
|||||
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
Refer to the Problem Symptoms Table (Click here).
Result Result
Proceed to
Fault is not listed in Problem Symptoms Table
A
Fault is listed in Problem Symptoms Table
B
|
|||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Data List / Active Test (Click here).
Terminals of ECU (Click here).
| |||||
| 8.ADJUST, REPAIR OR REPLACE |
| |||||
| 9.CONFIRMATION TEST |
| |||||