C1420 Acceleration Sensor Malfunction
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
Refer to DTC C1419 (Click here).| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1420 |
After the difference between GL1 and GL2 becomes 0.6 G or more with the vehicle stationary, the difference remains 0.4 G or more for 60 seconds or more. |
|
WIRING DIAGRAM
Refer to DTCs C1243 and C1245 (Click here).INSPECTION PROCEDURE
- NOTICE:
- When replacing the acceleration sensor, perform calibration (Click here).
- HINT:
- When DTC U0124 is output together with DTC C1420, inspect and repair the trouble areas indicated by DTC U0124 first (Click here).
| 1. CHECK ACCELERATION SENSOR INSTALLATION |
Check that the acceleration sensor is installed properly (Click here).
- OK:
- The sensor is tightened to the specified torque.
- The sensor is not installed at an angle.
|
|
||||
| OK | |
| 2. REPLACE ACCELERATION SENSOR |
Replace the acceleration sensor (Click here).
| NEXT | ||
| ||
