REMOVAL
Removal / installation · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use the same procedure for LHD and RHD vehicles.
- The procedure listed below is for LHD vehicles.
- Use the same procedure for LHD and RHD vehicles.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
| 2. REMOVE DOOR SCUFF PLATE ASSEMBLY RH |
- HINT:
- Use the same procedure described for the LH side.
for 3 Door: (Click here)
| 3. REMOVE COWL SIDE TRIM BOARD RH |
- HINT:
- Use the same procedure described for the LH side.
for 3 Door: (Click here)
| 4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
Remove the screw.
Detach the 3 clips and 2 guides and remove the No. 2 instrument panel under cover.


Text in Illustration *A
for LHD
*B
for RHD
| 5. REMOVE INSTRUMENT SIDE PANEL RH |
![]() ![]() |
Put protective tape around the instrument side panel.
Text in Illustration *1
Protective Tape
Using a moulding remover, detach the 5 clips, claw, and 3 guides.
Disconnect the connector and remove the instrument side panel.
| 6. REMOVE INSTRUMENT PANEL ORNAMENT |
Attach the 5 clips to install the instrument panel ornament.
| 7. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY |
![]() ![]() |
Remove the 2 bolts <C> and 2 screws <A> or <B>.
Text in Illustration *1
Bolt
*2
Screw
Detach the 5 clips and claw.
Disconnect each connector and remove the glove compartment door.
| 8. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY |
Remove the screw.

Detach the 2 claws and remove the No. 2 air duct sub-assembly.
| 9. REMOVE ECU INTEGRATION BOX RH |
Disconnect the connectors.

Detach the harness clamp.
Remove the 2 nuts, bolt and ECU integration box RH.
| 10. REMOVE NETWORK GATEWAY ECU |
Detach the 2 claws and remove the network gateway ECU from the ECU integration box RH.



