2013-2015 Land Cruiser Prado · Service Manual Steering

INSTALLATION

Removal / installation · Vehicles built from Aug 2013


1. INSTALL RACK AND PINION POWER STEERING GEAR ASSEMBLY
  1. Install the steering gear assembly with the 2 bolts and 2 nuts.

    Torque:
    120 N*m{ 1224 kgf*cm , 89 ft.*lbf }

    NOTICE:
    Hold the nuts and tighten the bolts to install the power steering link assembly.


2. CONNECT PRESSURE FEED TUBE ASSEMBLY (for LHD)
  1. Install the pressure feed tube clamp with the bolts.

    Torque:
    28 N*m{ 286 kgf*cm , 21 ft.*lbf }

  1. Connect the pressure feed tube (return tube side) to the steering gear with the clamp.

  1. Using a union nut wrench, connect the pressure feed tube (pressure feed tube side) to the steering gear and connect the tube to the vane pump.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }

    HINT:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).


3. CONNECT PRESSURE FEED TUBE ASSEMBLY (for RHD)

HINT:
Use the same procedure described for LHD vehicles.


4. CONNECT TIE ROD END SUB-ASSEMBLY LH
  1. Connect the tie rod end to the steering knuckle with the nut.

    Torque:
    91 N*m{ 928 kgf*cm , 67 ft.*lbf }

    NOTICE:
    Tighten the nut up to an additional 60° if the holes for the cotter pin are not aligned.

  1. Install a new cotter pin.


5. CONNECT TIE ROD END SUB-ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.


6. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT
  1. for Manual Tilt and Manual Telescopic Steering Column:
    Connect the No. 2 steering intermediate shaft (Click here).

  1. for Power Tilt and Power Telescopic Steering Column:
    Connect the No. 2 steering intermediate shaft (Click here).


7. INSTALL ENGINE ASSEMBLY
  1. for 1GR-FE:
    Install the engine (Click here).

  1. for 1KD-FTV:
    Install the engine (Click here).

  1. for 5L-E:
    Install the engine (Click here).

  1. for 2TR-FE:
    Install the engine (Click here).


8. ADD POWER STEERING FLUID

9. BLEED POWER STEERING FLUID
  1. for 1GR-FE:
    Bleed the power steering fluid (Click here).

  1. for 1KD-FTV:
    Bleed the power steering fluid (Click here).

  1. for 5L-E:
    Bleed the power steering fluid (Click here).

  1. for 2TR-FE:
    Bleed the power steering fluid (Click here).


10. CHECK FOR POWER STEERING FLUID LEAK

11. INSTALL FRONT WHEELS

Torque:
for steel wheel:
112 N*m{ 1137 kgf*cm , 82 ft.*lbf }
for aluminum wheel:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }


12. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

13. ADJUST FRONT WHEEL ALIGNMENT
(Click here)
← REASSEMBLY (from Aug 2013)PRECAUTION (from Aug 2013) →