2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This circuit is the power source circuit to operate the parking assist ECU. The parking assist ECU controls the parking assist monitor system and side monitor system.

HINT:
  1. The parking assist ECU is connected to other ECUs via CAN communication or AVC-LAN communication.
  2. for Navigation Receiver Type:
    If the parking assist ECU does not operate due to a power source problem, a navigation system DTC may be stored due to an AVC-LAN communication interruption.
  3. for Radio and Display Type:
    If the parking assist ECU does not operate due to a power source problem, an audio and visual system DTC may be stored due to an AVC-LAN communication interruption.
  4. If the parking assist ECU does not operate due to a power source problem, other system DTCs may be stored due to a CAN communication interruption.


WIRING DIAGRAM

E182726E85

INSPECTION PROCEDURE

NOTICE:
Inspect the fuse for circuits related to this system before performing the following inspection procedure.


1. CHECK FOR DTC (NAVIGATION SYSTEM OR AUDIO AND VISUAL SYSTEM)
  1. Clear the DTCs.

    1. for Navigation Receiver Type: Click here
    2. for Radio and Display Type: Click here

  1. Check for DTCs.

    1. for Navigation Receiver Type: Click here
    2. for Radio and Display Type: Click here

    OK:
    DTC B15D8 is not output.

    HINT:
    The parking assist ECU is connected to the navigation receiver assembly*1 or radio and display receiver assembly*2 by AVC-LAN communication line. DTC B15D8 may be stored to the navigation receiver assembly*1 or radio and display receiver assembly*2 due to the power source condition or changes in the power supply waveform for the parking assist ECU, even though there is no problem with the AVC-LAN communication system.
    1. *1: for Navigation Receiver Type
    2. *2: for Radio and Display Type

    Result 
    Result
    Proceed to
    OK
    A
    NG (for Navigation Receiver Type)
    B
    NG (for Radio and Display Type)
    C



B
GO TO NAVIGATION SYSTEM (Click here)

C
GO TO AUDIO AND VISUAL SYSTEM (Click here)
A


2. CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - BATTERY AND BODY GROUND)

  1. E245332E38
    Disconnect the I6 parking assist ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I6-4 (GND1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I6-1 (+B) - I6-4 (GND1)
    Always
    10 to 16 V

Text in Illustration 
*a
Front view of wire harness connector
(to Parking Assist ECU)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← ECU Power Source Circuit (Aug 2013 – Jul 2014)PRECAUTION (Aug 2013 – Jul 2014) →