2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

Pre-crash Safety Brake Cancel Switch Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The driving support ECU receives pre-crash brake on/off signals from the pre-crash brake cancel switch assembly.

WIRING DIAGRAM

E169489E29

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER
  1. Use the Data List to check if the pre-crash brake cancel switch assembly is functioning properly (Click here).

    Pre-Crash 2 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Pre-Crash Brake OFF Switch
    Pre-crash brake cancel switch assembly signal / ON or OFF
    ON: Pre-crash brake cancel switch assembly on
    OFF: Pre-crash brake cancel switch assembly off
    -

    OK:
    On screen, each item changes between ON and OFF according to above chart.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT PRE-CRASH BRAKE CANCEL SWITCH ASSEMBLY

  1. E118525E41
    Remove the pre-crash brake cancel switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (GND) - 2 (ECU)
    Pressed
    Below 1 Ω
    Not pressed
    10 kΩ or higher



NG
REPLACE PRE-CRASH BRAKE CANCEL SWITCH ASSEMBLY (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (PRE-CRASH BRAKE CANCEL SWITCH - DRIVING SUPPORT ECU)
  1. Disconnect the G121 switch connector.

  1. Disconnect the G119 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G121-2 (ECU) - G119-5 (PBSW)
    Always
    Below 1 Ω
    G121-1 (GND) - Body ground
    G121-2 (ECU) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE DRIVING SUPPORT ECU (Click here)


← U1104 Lost Communication with Driving Support ECU (from Aug 2014)Pre-crash Safety Brake Cancel Switch Circuit (from Aug 2014) →