2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

C1A02 Vehicle Information Not Obtained

Diagnostic trouble codes · Vehicles built from Aug 2013

DESCRIPTION

When the driving support ECU is replaced with a new one, it acquires the country specification information from the main body ECU (multiplex network body ECU). If the driving support ECU cannot store the country specification information, DTC C1A02 is stored.
DTC Code
DTC Detection Condition
Trouble Area
C1A02
While the ignition switch is ON and the pre-crash safety system is operating, the driving support ECU cannot store the country specification information.
  1. Main body ECU (Multiplex network body ECU)
  2. Driving support ECU

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Use the Data List to check if the country specification information is correct (Click here).

    Pre-Crash 2 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Country# (DSS)
    Driving support ECU country signal / JPN, NA, EURO, AUS, SAFC, OTHER, TWN, CHINA, THAI, GCC or NOFIX
    EURO, AUS, TWN, THAI or GCC
    -

    OK:
    Country specification information is correct.



NG
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND DRIVING SUPPORT ECU
OK


2. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC C1A02 is not output.



NG
REPLACE DRIVING SUPPORT ECU (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)


← C1A01 Driving Support ECU (from Aug 2013)C1A0A Front Radar Sensor Region Code Mismatch (from Aug 2013) →