2013-2015 Land Cruiser Prado · Service Manual Suspension

PROBLEM SYMPTOMS TABLE

Troubleshooting · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table.
    Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.

Kinetic Dynamic Suspension System 
Symptom
Suspected Area
See page
Kinetic dynamic suspension system DTC cannot be output (When using intelligent tester)
CAN communication system (for LHD)
Click here
CAN communication system (for RHD)
Click here
Harness or connector (power source of stabilizer control ECU)
Click here
Stabilizer control ECU
Click here
Kinetic dynamic suspension system DTC cannot be output (When not using intelligent tester)
CAN communication system (for LHD)
Click here
CAN communication system (for RHD)
Click here
Harness or connector (power source of stabilizer control ECU)
Click here
Stabilizer control ECU
Click here
Combination meter
Click here
KDSS indicator light does not come on
CAN communication system (for LHD)
Click here
CAN communication system (for RHD)
Click here
Combination meter
Click here
Vehicle is tilted
Stabilizer control solenoid valve
Click here
Fluid leakage
Click here
Bleed air (check for clogs in hydraulic circuit and lack or excess of fluid)
Click here
Roll is not controlled when driving
Brake control system
Click here
Stabilizer control solenoid valve
Click here
Fluid leakage
Click here
Bleed air (check for clogs in hydraulic circuit and lack or excess of fluid)
Click here
Accumulator pressure sensor
Click here
← PROBLEM SYMPTOMS TABLE (Aug 2013 – Jul 2014)TERMINALS OF ECU (from Aug 2013) →