INSTALLATION
Removal / installation · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| 1. INSTALL DOOR CONTROL RECEIVER |
Install the receiver with the bolt.
- Torque:
- 5.5 N*m{ 56 kgf*cm , 49 in.*lbf }
Connect the connector.
| 2. INSTALL REAR QUARTER TRIM PANEL ASSEMBLY LH |
Attach the 4 claws and 2 guides and pass the rear No. 1 seat outer belt floor anchor through the rear quarter trim panel.
Attach the 7 clips to install the rear quarter trim panel.
| 3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH |
Attach the 9 claws and 11 clips to install the deck trim side panel.
Install the 3 bolts and 2 screws.
Install the rear No. 1 seat outer belt floor anchor with the bolt.
- Torque:
- 42 N*m{ 428 kgf*cm , 31 ft.*lbf }
Install the front seat outer belt floor anchor with the bolt.
- Torque:
- 42 N*m{ 428 kgf*cm , 31 ft.*lbf }
| 4. INSTALL OUTER LAP BELT ANCHOR COVER |
- HINT:
- Use the same procedure for the other outer lap belt anchor cover.
Attach the 3 claws to install the outer lap belt anchor cover.
| 5. INSTALL QUARTER TRIM POCKET TRAY |
Attach the 6 claws and 2 guides to install the quarter trim pocket tray.
| 6. INSTALL FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover) |
- HINT:
- Use the same procedure for the other front deck side trim cover.
Attach the 2 claws to install the front deck side trim cover.
| 7. INSTALL NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover) |
- HINT:
- Use the same procedure for the other tonneau cover holder cap.
Attach the 2 claws to install the tonneau cover holder cap.
| 8. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK |
- HINT:
- Use the same procedure for the other No. 1 luggage compartment trim hook.
Install the No. 1 luggage compartment trim hook so that it is positioned horizontally.
| 9. INSTALL REAR FLOOR CARPET ASSEMBLY |
Install the rear floor carpet.
| 10. INSTALL QUARTER TRIM COVER HOLE LH |
Attach the 2 claws and 2 guides to install the quarter trim cover hole.
| 11. INSTALL QUARTER TRIM COVER HOLE RH |
- HINT:
- Use the same procedure described for the LH side.
| 12. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE |
Attach the 6 claws to install the rear floor mat rear support plate.
Install the 5 screws.
| 13. INSTALL MAT SET PLATE COVER |
- HINT:
- Use the same procedure for all mat set plate covers.
Attach the 2 claws to install the mat set plate cover.
| 14. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) |
Install the tonneau cover.
| 15. INSTALL REAR NO. 1 SEAT ASSEMBLY (w/ Rear No. 1 Seat) |
for LH Side:
Install the rear No. 1 seat assembly (Click here).
for RH Side:
Install the rear No. 1 seat assembly (Click here).
| 16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
