2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover, for 3 Door)
  1. Remove the tonneau cover.


2. REMOVE MAT SET PLATE COVER (for 3 Door)

B240525E01

HINT:
Use the same procedure for all mat set plate covers.

  1. Using a screwdriver, detach the 2 claws and remove the mat set plate cover.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective tape


3. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE (for 3 Door)

B240526
  1. Remove the 5 screws.

  1. Detach the 6 claws and remove the rear floor mat rear support plate.


4. REMOVE REAR FLOOR CARPET ASSEMBLY (for 3 Door)

B240527
  1. Remove the rear floor carpet.


5. REMOVE REAR NO. 2 SEAT ASSEMBLY (w/ Rear No. 2 Seat, for 5 Door)
  1. for Manual Seat Type:
    Remove the rear No. 2 seat assembly (Click here).

  1. for Power Seat Type:
    Remove the rear No. 2 seat assembly (Click here).

  1. for Face to Face Seat Type:
    Remove the rear No. 2 seat assembly (Click here).


6. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover, for 5 Door)
  1. Remove the tonneau cover.


7. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (w/o Rear No. 2 Seat, for 5 Door)

B240044

HINT:
Use the same procedure for the other front luggage compartment trim cover.

  1. Detach the 4 claws and remove the cap.

  1. B238749E01
    Remove the bolt, luggage hold belt striker and front luggage compartment trim cover.
    Text in Illustration 
    *1
    Luggage Hold Belt Striker


8. REMOVE NO. 1 DECK BOARD SUB-ASSEMBLY (w/o Rear No. 2 Seat, for 5 Door)

B238750
  1. Detach the clip and remove the No. 1 deck board.


9. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE (w/o Rear No. 2 Seat, for 5 Door)

B238748
  1. Detach the 5 clips and 4 claws and remove the rear floor mat rear support plate.


10. REMOVE FLOOR SIDE RAIL LH (w/ Deck Rail, for 5 Door)

B238764
  1. Remove the 3 bolts and floor side rail.


11. REMOVE FLOOR SIDE RAIL RH (w/ Deck Rail, for 5 Door)

HINT:
Use the same procedure described for the LH side.


12. REMOVE REAR FLOOR CARPET ASSEMBLY (w/o Rear No. 2 Seat, for 5 Door)

  1. Detach the 4 claws and remove the rear floor carpet.

    B238751E01

    Text in Illustration 
    *A
    w/o Deck Rail
    *B
    w/ Deck Rail
    *C
    for Face to Face Seat Type
    -
    -


13. REMOVE INDOOR NO. 3 ELECTRICAL KEY ANTENNA ASSEMBLY

  1. B241240E01
    Disconnect the connector.
    Text in Illustration 
    *A
    for 3 Door
    *B
    for 5 Door

  1. Detach the 2 claws and remove the indoor No. 3 electrical key antenna assembly.

← REMOVAL (Aug 2013 – Jul 2014)INSTALLATION (Aug 2013 – Jul 2014) →