2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Parking Brake Switch Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This circuit includes the parking brake switch assembly and navigation receiver assembly.

WIRING DIAGRAM

E280960E03

INSPECTION PROCEDURE

HINT:
When replacing the navigation receiver assembly, it is necessary to perform the vehicle contract setting for Connected Services (w/ Connected Services Function).


1. CHECK VEHICLE SIGNAL (OPERATION CHECK)

  1. E278090
    Display the "Vehicle Signal Check Mode" screen (Click here).

  1. Check that the display changes between ON and OFF according to the parking brake operation.

    OK:
    Parking Brake Condition
    Display
    Applied
    ON
    Released
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual parking brake operation.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARKING BRAKE SWITCH ASSEMBLY)
  1. Disconnect the H56 navigation receiver assembly connector.

  1. Disconnect the G77 parking brake switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H56-15 (PKB) - G77-1
    Always
    Below 1 Ω
    H56-15 (PKB) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT PARKING BRAKE SWITCH ASSEMBLY
  1. Remove the parking brake switch assembly (Click here).

  1. Inspect the parking brake switch assembly (Click here).



NG
REPLACE PARKING BRAKE SWITCH ASSEMBLY (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Illumination Circuit (from Aug 2014)Parking Brake Switch Circuit (from Aug 2014) →