HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use the following procedure to troubleshoot the blind spot monitor system.
- *: Use the GTS.
- Use the following procedure to troubleshoot the blind spot monitor system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| |||||
| 3.INSPECT BATTERY VOLTAGE |
Measure the battery voltage.
- Standard voltage:
- 11 to 14 V
| |||||
| 4.CHECK CAN COMMUNICATION SYSTEM* |
Use the GTS to check if the CAN communication system is functioning normally.
Result Result
Proceed to
CAN DTC is not output
A
CAN DTC is output (for LHD with Entry and Start System)
B
CAN DTC is output (for LHD without Entry and Start System)
C
CAN DTC is output (for RHD with Entry and Start System)
D
CAN DTC is output (for RHD without Entry and Start System)
E
|
|||||
|
|||||
|
|||||
|
|||||
| |||||
| 5.CHECK FOR DTC AND FREEZE FRAME DATA* |
Refer to DTC Check / Clear for the blind spot monitor system (Click here).
Record or print DTCs and freeze frame data, if necessary (Click here).
Result Result
Proceed to
DTCs are output.
A
DTCs are not output.
B
|
|||||
| |||||
| 6.CLEAR DTC* |
Refer to DTC Check / Clear for the blind spot monitor system (Click here).
- HINT:
- The current DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.
| |||||
| 7.RECHECK FOR DTC* |
Refer to DTC Check / Clear for the blind spot monitor system (Click here).
Result Result
Proceed to
DTCs are output.
A
DTCs are not output.
B
- HINT:
- Even if the malfunction symptom is not confirmed, check for DTCs. This is because the system stores history DTCs.
|
|||||
| |||||
| 8.DIAGNOSTIC TROUBLE CODE CHART |
Find the output DTC in Diagnostic Trouble Code Chart (Click here).
| |||||
| 9.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
Result Result
Proceed to
Fault is not listed in Problem Symptoms Table.
A
Fault is listed in Problem Symptoms Table.
B
- HINT:
- If the symptom does not recur and no DTC is output, attempt to reproduce the symptoms (Click here).
|
|||||
| |||||
| 10.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM* |
Refer to Terminals of ECU (Click here).
Refer to Data List / Active Test (Click here).
| |||||
| 11.CIRCUIT INSPECTION |
| |||||
| 12.ADJUST, REPAIR OR REPLACE |
| |||||
| 13.PERFORM BEAM AXIS INSPECTION AND CONFIRMATION |
Enter Test Mode (refer to Blind Spot Monitor Beam Axis Inspection) (Click here).
Confirm the blind spot monitor beam axis display and perform the blind spot monitor beam axis adjustment (Click here).
| |||||
| 14.PERFORM CONFIRMATION TEST* |
| |||||