2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the following procedure to troubleshoot the blind spot monitor system.
  2. *: Use the GTS.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
      NEXT

      3.INSPECT BATTERY VOLTAGE
      1. Measure the battery voltage.

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

      NEXT

      4.CHECK CAN COMMUNICATION SYSTEM*
      1. Use the GTS to check if the CAN communication system is functioning normally.

        Result 
        Result
        Proceed to
        CAN DTC is not output
        A
        CAN DTC is output (for LHD with Entry and Start System)
        B
        CAN DTC is output (for LHD without Entry and Start System)
        C
        CAN DTC is output (for RHD with Entry and Start System)
        D
        CAN DTC is output (for RHD without Entry and Start System)
        E


      B.

      C.

      D.

      E.
      A

      5.CHECK FOR DTC AND FREEZE FRAME DATA*
      1. Refer to DTC Check / Clear for the blind spot monitor system (Click here).

      2. Record or print DTCs and freeze frame data, if necessary (Click here).

        Result 
        Result
        Proceed to
        DTCs are output.
        A
        DTCs are not output.
        B


      B.
      A

      6.CLEAR DTC*
      1. Refer to DTC Check / Clear for the blind spot monitor system (Click here).

        HINT:
        The current DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.

      NEXT

      7.RECHECK FOR DTC*
      1. Refer to DTC Check / Clear for the blind spot monitor system (Click here).

        Result 
        Result
        Proceed to
        DTCs are output.
        A
        DTCs are not output.
        B

        HINT:
        Even if the malfunction symptom is not confirmed, check for DTCs. This is because the system stores history DTCs.


      B.
      A

      8.DIAGNOSTIC TROUBLE CODE CHART
      1. Find the output DTC in Diagnostic Trouble Code Chart (Click here).

      NEXT

      9.PROBLEM SYMPTOMS TABLE
      1. Refer to Problem Symptoms Table (Click here).

        Result 
        Result
        Proceed to
        Fault is not listed in Problem Symptoms Table.
        A
        Fault is listed in Problem Symptoms Table.
        B

        HINT:
        If the symptom does not recur and no DTC is output, attempt to reproduce the symptoms (Click here).


      B.
      A

      10.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM*
      1. Refer to Terminals of ECU (Click here).

      2. Refer to Data List / Active Test (Click here).

      NEXT

      11.CIRCUIT INSPECTION
        NEXT

        12.ADJUST, REPAIR OR REPLACE
          NEXT

          13.PERFORM BEAM AXIS INSPECTION AND CONFIRMATION
          1. Enter Test Mode (refer to Blind Spot Monitor Beam Axis Inspection) (Click here).

          2. Confirm the blind spot monitor beam axis display and perform the blind spot monitor beam axis adjustment (Click here).

          NEXT

          14.PERFORM CONFIRMATION TEST*
            NEXT

            ← SYSTEM DESCRIPTION (from Aug 2013)HOW TO PROCEED WITH TROUBLESHOOTING (from Aug 2014) →