2013-2015 Land Cruiser Prado · Service Manual Suspension

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the following procedure to troubleshoot the tire pressure warning system.
  2. *: Use the GTS.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.ADJUST TIRE PRESSURE*
    1. Turn the ignition switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the ignition switch ON.

    4. Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

    5. Set the pressure of each tire to the specified value (Click here).

      NOTICE:
      Make sure the tires are cooled down when adjusting the tire pressure.

    6. Display "ID Tire Inflation Pressure" in the Data List and check that tire pressure data matches the adjusted tire pressure.

      HINT:
      It takes a few minutes to display the updated tire pressure data.

    7. Perform initialization (Click here).

    8. HINT:
      for ECE-R64 Type:
      The warning threshold value changes depending on the driving conditions during initialization. As a result, the tire pressure warning light may not turn off even if the tire pressure is adjusted to the specified pressure.

      Result:
      Condition
      Proceed to
      Tire pressure warning light remains on
      A
      Tire pressure warning light goes off
      B


    B.
    A

    3.CHECK FOR DTC*
    1. Check for DTCs (Click here).

      Result:
      Result
      Proceed to
      DTC is output
      A
      DTC is not output
      B


    B.
    A

    4.DTC CHART
    1. Refer to Diagnostic Trouble Code Chart (Click here).

    NEXT

    5.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

    NEXT

    6.CIRCUIT INSPECTION*
    1. Refer to Electronic Circuit Inspection Procedure (Click here).

    NEXT

    7.REPAIR OR REPLACE
    1. Repair or replace parts based on the diagnosis result.

    NEXT

    8.CONFIRMATION TEST*
    1. Check the Data List to confirm that the tire inflation pressure has been received (Click here).

    2. Perform initialization (Click here).

    3. Confirm that the initialization has been completed.

    NEXT

    ← SYSTEM DESCRIPTION (from Aug 2013)HOW TO PROCEED WITH TROUBLESHOOTING (from Aug 2014) →