11381A
1.INSTALL REAR CRANKSHAFT OIL SEAL
Using SST and a hammer, tap in a new oil seal until its surface is flush with the oil seal retainer edge.
Apply MP grease to lip of the oil seal.
11381
2.INSTALL REAR CRANKSHAFT OIL SEAL RETAINER
Install a new gasket and the retainer with the 4 bolts.
11301C
3.INSTALL FRONT CRANKSHAFT OIL SEAL
11301
4.INSTALL TIMING BELT CASE SUB-ASSEMBLY
15104
5.INSTALL OIL STRAINER SUB-ASSEMBLY
12101
6.INSTALL OIL PAN SUB-ASSEMBLY
13521P
7.INSTALL CRANKSHAFT TIMING PULLEY
13505
8.INSTALL NO. 1 TIMING BELT IDLER SUB-ASSEMBLY
16100
9.INSTALL WATER PUMP ASSEMBLY
13502
10.INSTALL NO. 2 TIMING BELT IDLER SUB-ASSEMBLY
Install the spacer and No. 2 timing belt idler with the bolt.
Check that the No. 2 timing belt idler moves smoothly.
11115
11.INSTALL CYLINDER HEAD GASKET
11101
12.INSTALL CYLINDER HEAD SUB-ASSEMBLY
13511
13.INSTALL CAMSHAFT
11305A
14.INSTALL CAMSHAFT OIL SEAL
11385
15.INSTALL CAMSHAFT OIL SEAL RETAINER
11201
16.INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY
Remove any old packing (FIPG material).
Apply seal packing to the cylinder head as shown in the illustration.
Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent
| *1 | Seal Packing |
Install the gasket to the cylinder head cover.
Install the cylinder head cover with the 9 bolts and nut. Uniformly tighten the bolts and nut in several steps.
11322B
17.INSTALL NO. 2 TIMING BELT COVER
13523P
18.INSTALL CAMSHAFT TIMING PULLEY
11401G
19.INSTALL CRANKSHAFT POSITION SENSOR