When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
28800
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
52129B
2.REMOVE FRONT BUMPER LOWER COVER
51405A
3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
4.DRAIN ENGINE COOLANT
55781E
5.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
Remove the cowl top ventilator louver (See page Vehicle Exterior>WIPER / WASHER>FRONT WIPER MOTOR>REMOVAL).
26100G
6.REMOVE DIESEL THROTTLE BODY ASSEMBLY
Remove the diesel throttle body (See page Engine / Hybrid System>1KD-FTV (ENGINE CONTROL)>DIESEL THROTTLE BODY>REMOVAL).
16267
7.DISCONNECT NO. 3 WATER BY-PASS HOSE
16281
8.DISCONNECT NO. 4 WATER BY-PASS HOSE
9.REMOVE INJECTION PIPE
17871A
10.REMOVE AIR CONNECTOR STAY
82121
11.DISCONNECT ENGINE WIRE (for LHD)
82121
12.DISCONNECT ENGINE WIRE (for RHD)
25625
13.REMOVE EGR VALVE BRACKET
14.REMOVE ELECTRIC VACUUM REGULATING VALVE ASSEMBLY
17862A
15.REMOVE NO. 2 INTAKE AIR CONNECTOR
17861F
16.REMOVE INTAKE AIR CONNECTOR
25800
17.REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY WITH NO. 2 EGR VALVE AND EGR COOLER
25800
18.REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY
25624
19.REMOVE EGR VALVE ADAPTER
25630
20.REMOVE NO. 2 EGR VALVE ASSEMBLY
25601
21.REMOVE EGR COOLER