Home › Engine / Hybrid System › 2TR-FE (INTAKE / EXHAUST) › INTAKE MANIFOLD › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053676 2TR-FE INTAKE / EXHAUST _0260634 INTAKE MANIFOLD A

2TR-FE INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 53737B 3.REMOVE FRONT FENDER APRON SEAL LH

a.
C213692

Remove the 5 clips and front fender apron seal LH.


Hide 53737A 4.REMOVE FRONT NO. 1 FENDER APRON TO FRAME SEAL LH

a.
C213693

Remove the 5 clips and front No. 1 fender apron to frame seal LH.


Hide 22030 6.REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY

Hide 23250 7.REMOVE FUEL DELIVERY PIPE WITH FUEL INJECTOR

Hide 17111 9.REMOVE INTAKE MANIFOLD

a.
C213694

Detach the 2 wire harness clamps from the 2 wire harness clamp brackets.


b.
A308880

Detach the No. 2 water by-pass hose from the intake manifold.


c.

Slide the clip and disconnect the No. 3 ventilation hose from the intake manifold.


d.
A353236

Remove the 2 No. 2 intake manifold insulators from the intake manifold.


e.
A359643

Remove the 5 bolts, 2 nuts and intake manifold.


f.

Remove the gasket from the intake manifold.


g.

Remove the intake manifold insulator from the intake manifold.


h.
C213698

Remove the 2 bolts, 2 wire harness clamp brackets from the intake manifold.


i.

Slide the clip and remove the purge line hose from the intake manifold.