Home › Engine / Hybrid System › 1GD-FTV (INTAKE / EXHAUST) › EXHAUST PIPE › 2015.06–2017.08
RM27T0E _51 Engine / Hybrid System _053680 1GD-FTV INTAKE / EXHAUST _0260653 EXHAUST PIPE A

1GD-FTV INTAKE / EXHAUST  EXHAUST PIPE  REMOVAL  


PROCEDURE

Hide 17430 1.REMOVE TAILPIPE ASSEMBLY

a.

Remove the 2 bolts and disconnect the tailpipe assembly from the exhaust pipe support.


b.

Remove the gasket.


Hide 89463A 2.REMOVE NITROGEN OXIDES SENSOR (w/ Urea SCR System)

Hide 89425C 3.REMOVE NO. 4 EXHAUST GAS TEMPERATURE SENSOR (w/ Urea SCR System)

Hide 17420 4.REMOVE CENTER EXHAUST PIPE ASSEMBLY

a.

for 3 Door:

Remove the 2 bolts and then disconnect the center exhaust pipe assembly from the 2 exhaust pipe supports.


b.

for 5 Door:

Remove the 2 bolts and then disconnect the center exhaust pipe assembly from the 3 exhaust pipe supports.


c.

Remove the gasket.


Hide 23203 5.REMOVE UREA INJECTOR SET (w/ Urea SCR System)

Hide 17410 6.REMOVE FRONT EXHAUST PIPE ASSEMBLY

NOTICE:
A372594

w/ Urea SCR System:

Do not hold the front exhaust pipe assembly at the location shown in the illustration. Otherwise, it may become deformed or damaged, adversely affecting its thermal insulation capabilities.


a.

Remove the exhaust pipe supports.


b.

w/ Urea SCR System:

Using a 14 mm union nut wrench, loosen the 2 bolts, 2 compression springs and front exhaust pipe assembly.


c.

w/o Urea SCR System:

Remove the 2 bolts, 2 compression springs and front exhaust pipe assembly.


d.

Remove the gasket.