16547
1.INSTALL NO. 1 RADIATOR SUPPORT BUSH
Install the 4 No. 1 radiator support bushes to the radiator assembly.
16534
2.INSTALL NO. 2 RADIATOR SUPPORT
Install the 2 No. 2 radiator supports to the radiator assembly.
16533B
3.INSTALL NO. 1 RADIATOR SUPPORT
Install the 2 No. 1 radiator supports to the radiator assembly.
4.INSTALL VACUUM TRANSMITTING PIPE SUB-ASSEMBLY
Attach the 2 clamps and install the vacuum transmitting pipe sub-assembly to the radiator assembly.
17940D
5.INSTALL INTERCOOLER ASSEMBLY
16562
6.INSTALL NO. 2 RADIATOR TO SUPPORT SEAL
16593
7.INSTALL NO. 1 RADIATOR AIR GUIDE
Install a new No. 3 radiator to support seal to the No. 1 radiator air guide.
Install the No. 1 radiator air guide to the radiator assembly with intercooler assembly with the 2 bolts.
16400
8.INSTALL RADIATOR ASSEMBLY WITH INTERCOOLER ASSEMBLY
Install 2 new No. 1 radiator to support seals to the radiator assembly.
Insert the tabs of the radiator support into the radiator service holes.
Install the radiator assembly with intercooler assembly to the radiator support with the 4 bolts.
16572D
9.CONNECT NO. 2 RADIATOR HOSE
Connect the No. 2 radiator hose to the radiator assembly and slide the clamp to secure the hose.
| *a | Upper |
| *b | RH Side |
Make sure the direction of the hose clamp is as shown in the illustration.
16711
10.INSTALL FAN SHROUD
17342F
11.INSTALL INTERCOOLER AIR HOSE
17341F
12.INSTALL NO. 1 AIR HOSE
16571C
13.INSTALL NO. 1 RADIATOR HOSE
82123
14.INSTALL NO. 3 ENGINE WIRE (for Cold Area Specification Vehicles)
53294C
15.INSTALL RADIATOR SIDE DEFLECTOR LH
Attach the 3 claws to the radiator support.
Install the radiator side deflector LH with the clip.
53293C
16.INSTALL RADIATOR SIDE DEFLECTOR RH
Attach the 3 claws to the radiator support.
Install the radiator side deflector RH with the clip.
52521
17.INSTALL FRONT BUMPER UPPER RETAINER
Install the front bumper upper retainer with the 3 bolts.
52119A
18.INSTALL FRONT BUMPER COVER
19.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for Cold Area Specification Vehicles)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
20.ADD ENGINE COOLANT
21.INSPECT FOR ENGINE COOLANT LEAK
51405A
22.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
52129B
23.INSTALL FRONT BUMPER LOWER COVER
53292A
24.INSTALL UPPER RADIATOR SUPPORT SEAL
Install the upper radiator support seal with the 13 clips.