53292A
1.REMOVE UPPER RADIATOR SUPPORT SEAL
52129B
2.REMOVE FRONT BUMPER COVER LOWER
51405A
3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
4.DRAIN ENGINE COOLANT
11259
5.REMOVE V-BANK COVER
16571C
6.REMOVE NO. 1 RADIATOR HOSE
16572D
7.REMOVE NO. 2 RADIATOR HOSE
16470
8.REMOVE RADIATOR RESERVOIR
32907C
9.DISCONNECT OIL COOLER TUBE (w/ Warmer)
32907C
10.DISCONNECT OIL COOLER TUBE (w/ Air Cooled Transmission Oil Cooler)
16711
11.REMOVE FAN SHROUD
17360
12.DISCONNECT AIR TUBE ASSEMBLY (w/o Oil Cooler)
Remove the 2 bolts and disconnect the air tube.
16323
13.REMOVE WATER INLET HOUSING (w/ Oil Cooler)
Disconnect the throttle body connector.
Disconnect the 5 water by-pass hoses.
Disconnect the oil cooler hose.
Disconnect the No. 2 oil cooler hose.
Remove the 5 bolts and water inlet.
Remove the O-ring from the water outlet pipe.
Remove the gasket from the water pump.
16323
14.REMOVE WATER INLET HOUSING (w/o Oil Cooler)
Disconnect the throttle body connector.
Disconnect the 5 water by-pass hoses.
Remove the 5 bolts and water inlet.
Remove the O-ring from the water outlet pipe.
Remove the gasket from the water pump.
16604
15.REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY
for Cover Separate Type:
Remove the 2 bolts, 2 idler pulley cover plates, 2 No. 2 idler pulleys and 2 No. 2 idler pulley cover plates.
for Cover Integrated Type:
Remove the 2 bolts and 2 No. 2 idler pulleys.
44320
16.DISCONNECT VANE PUMP ASSEMBLY
Disconnect the 2 connectors.
Detach the 2 wire harness clamps.
Remove the 2 bolts and disconnect the vane pump.
27020
17.REMOVE GENERATOR ASSEMBLY
Remove the generator assembly (See page Power Source / Network>1GR-FE (BATTERY / CHARGING)>GENERATOR>REMOVAL).
88320
18.REMOVE COOLER COMPRESSOR ASSEMBLY
Remove the cooler compressor assembly (See page Vehicle Interior>HEATING / AIR CONDITIONING>COMPRESSOR (for 1GR-FE)>REMOVAL).
16620
19.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
16100
20.REMOVE WATER PUMP ASSEMBLY
Remove the 17 bolts, water pump and gasket.