1.REMOVE ENGINE ASSEMBLY
Remove the engine (See page Engine / Hybrid System>5L-E (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL).
88431
2.REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET
13568
3.REMOVE TIMING BELT
Remove the timing belt (See page Engine / Hybrid System>5L-E (ENGINE MECHANICAL)>TIMING BELT>REMOVAL).
22100
4.REMOVE INJECTION PUMP ASSEMBLY
Remove the injection pump (See page Engine / Hybrid System>5L-E (FUEL)>FUEL INJECTION PUMP>REMOVAL).
16333
5.REMOVE WATER OUTLET HOUSING
16261B
6.REMOVE WATER BY-PASS HOSE UNION
44443
7.REMOVE PUMP BRACKET
12311
8.REMOVE NO. 1 FRONT ENGINE MOUNTING BRACKET RH
12315
9.REMOVE NO. 1 FRONT ENGINE MOUNTING BRACKET LH
12511
10.REMOVE NO. 1 GENERATOR BRACKET
13523P
11.REMOVE CAMSHAFT TIMING PULLEY
11322B
12.REMOVE NO. 2 TIMING BELT COVER
16100
13.REMOVE WATER PUMP ASSEMBLY
13505
14.REMOVE NO. 1 TIMING BELT IDLER SUB-ASSEMBLY
13502
15.REMOVE NO. 2 TIMING BELT IDLER SUB-ASSEMBLY
13521P
16.REMOVE CRANKSHAFT TIMING PULLEY
12101
17.REMOVE OIL PAN SUB-ASSEMBLY
Remove the 16 bolts and 2 nuts.
Insert the blade of an oil pan seal cutter between the oil pan and cylinder block, cut off the applied sealer and remove the oil pan.
Do not use an oil pan seal cutter for the timing belt case side and rear oil seal retainer.
Be careful not to damage the oil pan flange.
15104
18.REMOVE OIL STRAINER SUB-ASSEMBLY
Remove the 2 bolts, 2 nuts, oil strainer and gasket.
11301
19.REMOVE TIMING BELT CASE SUB-ASSEMBLY
Remove the 5 bolts, timing belt case and gasket.
11301C
20.REMOVE FRONT CRANKSHAFT OIL SEAL
Using a screwdriver, pry out the oil seal.
Tape the screwdriver tip before use.