| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1782/82 | The voltage at terminal IG or B is 10 V or less or 16 V or higher for 0.5 seconds. | ·
Battery ·
Charging system ·
AIR SUS fuse ·
AIR SUS NO. 2 fuse ·
AVS fuse ·
Harness or connector ·
Suspension control ECU |
When replacing the suspension control ECU, perform registration (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>REGISTRATION).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / Air suspension / Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| IG Power Source Voltage | Actual ECU power supply voltage / Min.: 0.0 V, Max.: 25.5 V | Ignition switch ON: 11 to 14 V | - |
| +B Power Source Voltage | Actual battery supply voltage / Min.: 0.0 V, Max.: 25.5 V | Ignition switch ON: 11 to 14 V | - |
11 to 14 V
| Result | Proceed to |
|---|---|
| NG | A |
| OK (When troubleshooting according to problem symptoms table) | B |
| OK (When troubleshooting according to DTC chart) | C |
A
B
C
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
Disconnect the A49 suspension control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A49-3 (B) - Body ground | Always | 11 to 14 V |
| A49-1 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector
(to Suspension Control ECU) |
OK
NG
Disconnect the A49 and R19 suspension control ECU connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| R19-10 (GND) - Body ground | Always | Below 1Ω |
| A49-5 (GND) - Body ground | Always | Below 1Ω |
OK
NG
Clear the DTCs (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B