This DTC is stored when the suspension control ECU is initialized and is cleared when the vehicle identification information received through CAN communication system is correctly stored in the EEPROM.
DTC C1789/89 is stored when an incorrect ECM is installed as the vehicle specification and data do not match.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1789/89 | Either condition is met:
·
The vehicle identification information is not stored. ·
The information stored in the suspension control ECU and the vehicle identification information received through CAN communication system do not match. |
·
Suspension control ECU ·
ECM |
When replacing the suspension control ECU, perform registration (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>REGISTRATION).
Do not exchange the suspension control ECU with a normally functioning one from another vehicle to perform troubleshooting.
Perform registration (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>REGISTRATION).
NEXT
Clear DTC (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>DTC CHECK / CLEAR).
Check if DTC C1789/89 is output (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>DTC CHECK / CLEAR).
DTC C1789/89 is not output.
OK
NG
Check that the part number of the installed ECM is correct (for 1KD-FTV: See page Engine / Hybrid System>1KD-FTV (ENGINE CONTROL)>ECM>REMOVAL, for 1GR-FE: See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>ECM>REMOVAL, for 1GD-FTV: See page Engine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECM>REMOVAL).
When removing the ECM to check the part number, or when replacing the ECM, be sure to follow the appropriate procedures and precautions.
ECM with correct part number is installed.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 1KD-FTV) | B |
| NG (for 1GR-FE) | C |
| NG (for 1GD-FTV) | D |
A
B
C
D
Clear the DTC (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>DTC CHECK / CLEAR).
NEXT
Check if DTC C1789/89 is output (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>DTC CHECK / CLEAR).
DTC C1789/89 is not output.
If no parts are replaced and DTC C1789/89 is output, there may be an internal malfunction in the suspension control ECU. In this case, replace the suspension control ECU.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG