Home › Suspension › SUSPENSION CONTROL › STABILIZER CONTROL VALVE(w/ KDSS) › 2015.06–2020.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260872 STABILIZER CONTROL VALVE(w/ KDSS) A

SUSPENSION CONTROL  STABILIZER CONTROL VALVE(w/ KDSS)  INSTALLATION  


PROCEDURE

Hide 48860D 1.INSTALL STABILIZER CONTROL WITH ACCUMULATOR HOUSING ASSEMBLY

a.

Install the stabilizer control with accumulator housing with the 3 bolts.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


b.

Connect the connector, and then attach the clamp to the hole of the bracket.


Hide 48890 2.CONNECT FRONT NO. 1 STABILIZER CONTROL TUBE ASSEMBLY

a.

Temporarily install the 2 flare nuts on the front No. 1 stabilizer control tube assembly.


b.
C301806

Using a union nut wrench, tighten the 2 flare nuts on the front No. 1 stabilizer control tube assembly.

Torque:
44 N*m (450 kgf*cm, 33 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 44327N 3.CONNECT REAR NO. 1 STABILIZER CONTROL TUBE ASSEMBLY

a.

Temporarily install the 2 flare nuts on the rear No. 1 stabilizer control tube assembly.


b.
C301807

Connect the rear No. 1 stabilizer control tube assembly with the 2 bolts.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


c.

Using a union nut wrench, tighten the 2 flare nuts on the rear stabilizer control tubes.

Torque:
44 N*m (450 kgf*cm, 33 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 5.APPLY PRESSURE ACCORDING TO TEMPERATURE MANAGEMENT CHART WHEN FILLING FLUID

Hide 48826D 8.INSTALL STABILIZER CONTROL VALVE PROTECTOR

a.

Install the stabilizer control valve protector with the 2 bolts.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).