Home › Suspension › SUSPENSION CONTROL › HEIGHT CONTROL COMPRESSOR › 2015.06–2020.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260873 HEIGHT CONTROL COMPRESSOR A

SUSPENSION CONTROL  HEIGHT CONTROL COMPRESSOR  INSTALLATION  


PROCEDURE

Hide 48911 1.INSTALL HEIGHT CONTROL COMPRESSOR BRACKET

a.

Install the height control compressor bracket with the 3 bolts.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


Hide 48910B 2.INSTALL HEIGHT CONTROL COMPRESSOR ASSEMBLY

a.

Install the 3 bushes to the height control compressor.


b.

Install a new O-ring.


c.

Install the height control dryer with the bolt

Torque:
6.4 N*m (65 kgf*cm, 57 in.*lbf)


d.

Install the height control compressor to the bracket with the 3 bolts.

Torque:
5.9 N*m (60 kgf*cm, 52 in.*lbf)


e.

Connect the connector.


f.

Attach the clamp.


g.

Attach the 3 clamps.


h.

Connect the connector.


i.

Attach the No. 2 height control tube.


Hide 48982 3.CONNECT NO. 2 HEIGHT CONTROL TUBE

a.
C214857

Connect the No. 2 height control tube (See page Suspension>SUSPENSION CONTROL>SUSPENSION CONTROL SYSTEM (w/ Air Suspension)>PRECAUTION).

HINT:

For the connection procedure of the tube (type 2), refer to Precaution of the Suspension Control System section.



Hide 48925 4.INSTALL HEIGHT CONTROL FILTER

a.

Install the height control filter with the 2 bolts.

Torque:
6.4 N*m (65 kgf*cm, 57 in.*lbf)


b.

Connect the 2 hoses with 2 new clips.


Hide 5.CHECK CONNECTIONS OF TUBES FOR AIR LEAK

a.

Check the connections of the tubes for air leakage (See page Suspension>SUSPENSION CONTROL>SUSPENSION CONTROL SYSTEM (w/ Air Suspension)>PRECAUTION).


Hide 52046A 6.INSTALL REAR BUMPER PROTECTOR SUB-ASSEMBLY LH (for 5 Door)

Hide 48978 7.INSTALL HEIGHT CONTROL COMPRESSOR COVER

a.

Install the height control compressor cover with 3 new clips.


Hide 76608 8.INSTALL REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH

Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).