Home › Suspension › SUSPENSION CONTROL › REAR ACCELERATION SENSOR › 2015.06–2020.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260880 REAR ACCELERATION SENSOR A

SUSPENSION CONTROL  REAR ACCELERATION SENSOR  INSTALLATION  


PROCEDURE

Hide 89190A 1.INSTALL REAR ACCELERATION SENSOR

a.
C213603

Install the rear acceleration sensor with the bolt as shown in the illustration.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:

Replace the rear acceleration sensor with a new one if it is dropped.



b.

Connect the connector.

NOTICE:

Securely connect the connector.



Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).