Home › Suspension › SUSPENSION CONTROL › REAR ACCELERATION SENSOR › 2015.06–2020.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260880 REAR ACCELERATION SENSOR A

SUSPENSION CONTROL  REAR ACCELERATION SENSOR  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 64740C 2.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 89190A 3.REMOVE REAR ACCELERATION SENSOR

a.
C213603

Disconnect the connector.


b.

Remove the bolt and rear acceleration sensor.

NOTICE:

Replace the rear acceleration sensor with a new one if it is dropped.