Home › Suspension › REAR SUSPENSION › REAR COIL SPRING(w/o Air Suspension)
RM27T0E _53 Suspension _053709 REAR SUSPENSION _0260901 REAR COIL SPRING(w/o Air Suspension) A

REAR SUSPENSION  REAR COIL SPRING(w/o Air Suspension)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 48302 1.INSTALL HOLLOW SPRING SUB-ASSEMBLY (for 5 Door)

a.

Install the hollow spring to the frame.


Hide 48231B 2.INSTALL REAR COIL SPRING LH

a.
D028471

Install the rear coil spring to the rear axle housing.

HINT:

Before installing the coil spring, check that the coil spring end is in the correct position. If not, reinstall the coil spring.



Hide 48540 3.TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH

a.

Temporarily install the lower side of the shock absorber with the bolt.


Hide 4.INSTALL REAR STABILIZER LOWER BRACKET (w/ KDSS)

Hide 48540 6.TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH

a.

Tighten the bolt.

Torque:
98 N*m (999 kgf*cm, 72 ft.*lbf)


Hide 47319F 7.CONNECT REAR FLEXIBLE HOSE

Hide 8. BLEED BRAKE LINE

a.

for Hydraulic Brake Booster:

Bleed the brake line (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE FLUID(for Hydraulic Brake Booster)>BLEEDING).


b.

for Vacuum Brake Booster:

Bleed the brake line (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (for Vacuum Brake Booster)>BLEEDING).


Hide 9.INSTALL REAR WHEEL

Torque:
for Aluminum Wheel : 103 N*m (1050 kgf*cm, 76 ft.*lbf)
for Steel Wheel : 112 N*m (1137 kgf*cm, 82 ft.*lbf)