Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR (w/ KDSS)
RM27T0E _53 Suspension _053709 REAR SUSPENSION _0260898 REAR STABILIZER BAR(w/ KDSS) A

REAR SUSPENSION  REAR STABILIZER BAR(w/ KDSS)  INSTALLATION  


PROCEDURE

Hide 48830 1.INSTALL REAR STABILIZER LINK ASSEMBLY

a.

Install the rear stabilizer link assembly with the bolt and nut.

Torque:
100 N*m (1020 kgf*cm, 74 ft.*lbf)

HINT:

Turn the nut while holding the bolt.



Hide 48885 2.INSTALL REAR STABILIZER CONTROL CYLINDER

a.

Install the 2 bleeder plug caps to the rear stabilizer control cylinder.


b.

Install the rear stabilizer control cylinder with the bolt and nut.

Torque:
100 N*m (1020 kgf*cm, 74 ft.*lbf)

NOTICE:

Do not hold the rear stabilizer control cylinder by the cylinder boot.


HINT:

Turn the nut while holding the bolt.



Hide 48880 3.CONNECT REAR STABILIZER CONTROL TUBE ASSEMBLY

a.
C214766

Connect the rear stabilizer control tube to the rear stabilizer control cylinder with the 2 union bolts and 2 new pressure port gaskets.

Torque:
69 N*m (704 kgf*cm, 51 ft.*lbf)

NOTICE:

Insert the stoppers of the rear stabilizer control tube into the rear stabilizer control cylinder.



Hide 48805 4.TEMPORARILY INSTALL REAR STABILIZER BAR SUB-ASSEMBLY

a.
U116006

Install the 2 rear stabilizer bushes to the rear stabilizer bar.

HINT:

Install the stabilizer bush to the outer side of the stabilizer bush stopper on the stabilizer bar.


Text in Illustration
V100136

Outer Side


b.

Temporarily install the rear stabilizer bar with the 2 bolts and nuts.


Hide 5.INSTALL REAR STABILIZER LOWER BRACKET

a.
F047862

Support the rear stabilizer bar with a jack.

NOTICE:

Place a wooden block between the jack and rear stabilizer bar to prevent damage.



b.
C214768E01
0.663,2.299 0.888,2.503 0.225,0.205 10 *1 2.558,2.269 2.783,2.474 0.225,0.205 10 *2 1.194,3.144 1.566,3.313 0.371,0.170 10 180° 1.947,3.143 2.337,3.313 0.390,0.170 10 180°

Install the rear stabilizer bar and 2 rear stabilizer lower brackets with the 4 bolts.

Torque:
45 N*m (459 kgf*cm, 33 ft.*lbf)

HINT:

Check that the protrusions on the rear stabilizer bush are positioned within 180° of the rear stabilizer control cylinder and rear stabilizer link.


Text in Illustration
*1 Rear Stabilizer Control Cylinder
*2 Rear Stabilizer Link


Hide 6.BLEED SUSPENSION FLUID

Hide 48805 8.TIGHTEN REAR STABILIZER BAR SUB-ASSEMBLY

a.

Tighten the 2 bolts and 2 nuts.

Torque:
110 N*m (1122 kgf*cm, 81 ft.*lbf)

NOTICE:

Turn the bolt while holding the nut.



Hide 48826D 9.INSTALL STABILIZER CONTROL VALVE PROTECTOR

Hide 10.INSTALL SIDE STEP ASSEMBLY LH (for 5 Door)

Hide 11.INSPECT VEHICLE HEIGHT