The skid control ECU measures the speed of each wheel by receiving signals from the speed sensors.
These signals are used for recognizing that all 4 wheels are operating properly.
Therefore, all wheel signals must indicate the same speed.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1337 | The following occurs in 3 consecutive trips:
At a vehicle speed of 20 km/h (12 mph) or more, there is a difference of 20% or more in the average speed between the front wheels and rear wheels for 20 seconds or more. |
·
Tire and wheel size ·
Tire deformation ·
Speed sensor rotor ·
Speed sensor ·
Speed sensor circuit ·
Brake actuator assembly (Skid control ECU) |
When replacing the brake actuator assembly, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>CALIBRATION).
When DTCs C1401 to C1416 are output with DTC C1337, inspect and repair the trouble areas indicated by DTCs C1401 to C1416 first (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
Check the size and condition of all 4 wheels (See page Suspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION).
The DTC is output when tire deformation or a difference in tire size is detected.
The diameter and air pressure of all 4 tires are the same.
OK
NG
Clear the DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR).
Start the engine.
Drive the vehicle at a speed of 40 km/h (25 mph) or more for at least 60 seconds.
Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C1337 is output | A |
| DTC C1337 is not output | B |
A
B
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)