Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster) › 2015.06–2017.08
RM27T0E _54 Brake _053712 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0260911 VEHICLE STABILITY CONTROL SYSTEM(for Hydraulic Brake Booster) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(for Hydraulic Brake Booster)  C1436  Yaw Rate Sensor Malfunction  


DESCRIPTION

Refer to DTC C1419 and C1435 (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>C1419).

DTC Code DTC Detection Condition Trouble Area
C1436 Either condition is met:
1.

With the vehicle stationary, the yaw rate and acceleration sensor output value is not 0°/s.

2.

An abnormal comparison value.


Yaw rate and acceleration sensor

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the yaw rate and acceleration sensor, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>CALIBRATION).



HINT:

When DTC U0123, U0124 and/or U0126 is output together with DTC C1436, inspect and repair the trouble areas indicated by DTC U0123, U0124 and/or U0126 first (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>U0073).


PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (YAW RATE SENSOR)
a.

Turn the ignition switch off.


b.

Connect the intelligent tester to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the intelligent tester on.


e.

Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

ABS/VSC/TRC
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Yaw Rate Sensor Yaw rate and acceleration sensor 1 reading/ Min.: -128°/s, Max.: 127°/s Vehicle stationary: 0°/s
Right turn: -128 to 0°/s
Left turn: 0 to 127°/s
-


f.

Check that the yaw rate and acceleration sensor output value is displayed on the intelligent tester.

Result
Result Proceed to
NG Yaw rate and acceleration sensor output value is 0°/s when vehicle is stationary, but value fluctuates when turning A
Yaw rate and acceleration sensor output value is not 0°/s when vehicle is stationary B
OK C



A

2.CHECK YAW RATE AND ACCELERATION SENSOR INSTALLATION

B

C

2.CHECK YAW RATE AND ACCELERATION SENSOR INSTALLATION
a.

Turn the ignition switch off.


b.

Check that the yaw rate and acceleration sensor is installed properly (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>YAW RATE AND ACCELERATION SENSOR>INSTALLATION).

OK:

The sensor is tightened to the specified torque.

The sensor is not installed at an angle.




OK

NG

INSTALL YAW RATE AND ACCELERATION SENSOR CORRECTLY