89183A
1.INSTALL YAW RATE AND ACCELERATION SENSOR
for Automatic Transmission:
Attach the clamp to the hole of the sensor bracket.
Connect the connector.
Securely connect the connector.
Install the yaw rate and acceleration sensor with the 2 bolts.
If the sensor is dropped, replace it.
Make sure the bracket rotation stopper touches the installation position.
Make sure that the sensor is oriented correctly.
When installing the sensor, make sure to avoid impacts to the sensor.
58530J
2.INSTALL CENTER FLOOR CARPET ASSEMBLY (for Bench Seat Type)
3.INSTALL FRONT SEAT ASSEMBLY (for Bench Seat Type)
58901A
4.INSTALL REAR CONSOLE BOX SUB-ASSEMBLY
for Automatic Transmission:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(for Automatic Transmission)>INSTALLATION)
for Manual Transmission:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(for Manual Transmission)>INSTALLATION)
w/ Refrigerated Cool Box:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX (w/ Refrigerated Cool Box)>INSTALLATION)
for Bench Seat Type:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(for Bench Seat Type)>INSTALLATION)
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
89183A
6.PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION
for Hydraulic Brake Booster:
for Vacuum Brake Booster:
89183A
7.CHECK YAW RATE AND ACCELERATION SENSOR SIGNAL
for Hydraulic Brake Booster:
for Vacuum Brake Booster: