Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster) › 2015.06–2017.08
RM27T0E _54 Brake _053712 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0260912 VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster) J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)  VSC Buzzer Circuit  


DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.

The combination meter assembly has a built-in buzzer.

WIRING DIAGRAM

C230884E32
5.344,1.479 6.865,1.938 1.521,0.458 10 false Skid Control ECU (Brake Actuator Assembly) 0.604,1.969 2.729,2.281 2.125,0.313 10 false Combination Meter Assembly 1.021,0.906 1.573,1.104 0.552,0.198 10 false Buzzer 0.906,2.427 3.135,2.656 2.229,0.229 10 false : CAN Communication Line 0.625,1.792 0.938,1.99 0.313,0.198 10 false G6 5.396,1.24 5.708,1.438 0.313,0.198 10 false A6

CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake actuator assembly), perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)>CALIBRATION).


PROCEDURE

2.READ VALUE USING INTELLIGENT TESTER (BUZZER)
a.

Turn the engine switch off.


b.

Connect the intelligent tester to the DLC3.


c.

Turn the engine switch on (IG).


d.

Turn the intelligent tester on.


e.

Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.


ABS/VSC/TRAC
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Buzzer Buzzer/ ON or OFF ON: Buzzer on
OFF: Buzzer off
The combination meter has a built-in buzzer.

f.

ABS/VSC/TRAC
Tester Display Test Part Control Range Diagnostic Note
Buzzer Buzzer Buzzer ON/OFF The buzzer can be heard.

Result
Result Proceed to
Data List Display Data List Display when Performing Active Test ON/OFF Operation
ON Changes between ON and OFF A
Does not change between ON and OFF B
OFF Changes between ON and OFF A
Does not change between ON and OFF B


A

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

B

3.INSPECT COMBINATION METER ASSEMBLY
3.INSPECT COMBINATION METER ASSEMBLY

OK

NG

REPLACE COMBINATION METER ASSEMBLY