Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster) › 2015.06–2017.08
RM27T0E _54 Brake _053712 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0260912 VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster) J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)  Slip Indicator Light Remains ON  


DESCRIPTION

The skid control ECU is connected to the combination meter via CAN communication.

The slip indicator light blinks during VSC and/or TRC operation.

When the system fails, the slip indicator light comes on to warn the driver.

WIRING DIAGRAM

C215179E01
5.255,2.035 5.543,2.256 0.288,0.221 10 A6 5.255,2.222 6.883,2.619 1.628,0.397 10 Brake Actuator Assembly (Skid Control ECU) 0.565,2.624 1.827,2.817 1.262,0.193 10 Combination Meter 0.662,3.157 3.758,3.369 3.096,0.212 10 : CAN Communication System 1.083,1.372 1.391,1.574 0.307,0.202 10 Slip 1.298,1.849 1.584,2.014 0.286,0.165 10 IG 0.864,0.695 1.237,0.994 0.373,0.299 10 CPU 0.565,2.423 0.943,2.641 0.378,0.218 10 G6

CAUTION / NOTICE / HINT

NOTICE:

When replacing the brake actuator assembly, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)>CALIBRATION).


PROCEDURE

2.READ VALUE USING INTELLIGENT TESTER (SLIP INDICATOR LIGHT)
a.

Turn the ignition switch off.


b.

Connect the intelligent tester to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the intelligent tester on.


e.

Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

ABS/VSC/TRC
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Slip Indicator Light Slip indicator light / ON or OFF OFF -


f.

When performing the Slip Indicator Light Active Test, check Slip Indicator Light in the Data List (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)>DTC CHECK / CLEAR).


ABS/VSC/TRC
Tester Display Test Part Control Range Diagnostic Note
Slip Indicator Light Slip indicator light Indicator light ON/OFF Observe the combination meter.

Result
Result Proceed to
Data List Display Data List Display when Performing Active Test ON/OFF Operation
ON Does not change between ON and OFF A
Changes between ON and OFF B
OFF Does not change between ON and OFF A
Changes between ON and OFF B


A

B

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)