Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER
RM27T0E _54 Brake _053713 BRAKE SYSTEM (OTHER) _0260929 BRAKE MASTER CYLINDER A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 47201 1.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

a.

for LHD:

i.

Install a new O-ring to the brake master cylinder sub-assembly.


ii.

Install the brake master cylinder with 2 nuts.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)


iii.

Using a union nut wrench, connect the 2 brake lines to the brake master cylinder sub-assembly.

Torque:
20 N*m (199 kgf*cm, 14 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



iv.

Attach the clamp and connect the connector.



b.

for RHD:

i.
C213479

Install a new O-ring to the brake master cylinder sub-assembly.


ii.

Install the brake master cylinder and new clamp to the brake booster with 2 nuts.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)


iii.

Using a union nut wrench, connect the 2 brake lines to the brake master cylinder sub-assembly.

Torque:
20 N*m (199 kgf*cm, 14 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



iv.

Connect the connector.



Hide 2.CONNECT CLUTCH TUBE (for Manual Transmission)

a.

Connect the clutch tube to the brake master cylinder reservoir assembly with the clip.


Hide 44510 3.INSTALL BRAKE ACTUATOR ASSEMBLY (for RHD)

a.

Install the brake actuator sub-assembly (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR>INSTALLATION).


Hide 4.INSTALL AIR CLEANER CASE (for 2TR-FE RHD)

Hide 17700 5.INSTALL AIR CLEANER CASE ASSEMBLY (for 5L-E RHD)

a.

Install the air cleaner case assembly (See page Engine / Hybrid System>5L-E (ENGINE MECHANICAL)>ENGINE ASSEMBLY>INSTALLATION).


Hide 7.FILL RESERVOIR WITH BRAKE FLUID

Hide 9.CHECK FLUID LEVEL IN RESERVOIR

Hide 10.CHECK FOR BRAKE FLUID LEAK FROM CLUTCH LINE