Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 1GD-FTV) › 2015.06–2020.08
RM27T0E _55 Steering _053717 POWER ASSIST SYSTEMS _0260953 VANE PUMP(for 1GD-FTV) A

POWER ASSIST SYSTEMS  VANE PUMP(for 1GD-FTV)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, do not overtighten it.

·

When installing the parts indicated by arrows, coat them with power steering fluid (See page Steering>POWER ASSIST SYSTEMS>VANE PUMP (for 1GD-FTV)>COMPONENTS).



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 12601B 2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 44348A 5.REMOVE NO. 1 OIL RESERVOIR TO PUMP HOSE

a.
C327748

Slide the clip and disconnect the No. 1 oil reservoir to pump hose.


Hide 44410 6.REMOVE PRESSURE FEED TUBE ASSEMBLY

a.
C327749

Disconnect the connector from the vane pump assembly.


b.
C327750

Remove the union bolt and pressure feed tube assembly from the vane pump assembly.


c.

Remove the gasket from the pressure feed tube assembly.


Hide 44320 7.REMOVE VANE PUMP ASSEMBLY

a.

Disconnect the connector from the vane pump assembly.


b.
C327751

Remove the 2 bolts and vane pump assembly.