Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR SEAT ENTERTAINMENT SYSTEM › 2015.06–2020.08
RM27T0E _56 Audio / Visual / Telematics _053720 AUDIO / VIDEO _0260968 REAR SEAT ENTERTAINMENT SYSTEM C

AUDIO / VIDEO  REAR SEAT ENTERTAINMENT SYSTEM  B15D5  Rear Seat Entertainment System Disconnected  


DESCRIPTION

*1: w/ Navigation System (for Navigation Receiver Type)

*2: w/ Navigation System (for Radio and Display Type) or w/o Navigation System


The navigation receiver assembly*1 or radio and display receiver assembly*2 and television display assembly are connected by the AVC-LAN communication line.

When an AVC-LAN communication error occurs between the navigation receiver assembly*1 or radio and display receiver assembly*2 and television display assembly, this DTC will be stored.

DTC Code DTC Detection Condition Trouble Area
B15D5 When either condition below is met:
·

The television display assembly is/was not connected while the ignition switch is ON or ACC.

·

Communication between the master unit and the television display assembly is not possible when the engine is started.


·

AVC-LAN communication line

·

Television display assembly

·

Navigation receiver assembly*1

·

Radio and display receiver assembly*2

·

Harness or connector



HINT:
·

Even if no fault is present, this DTC may be stored depending on the battery condition or engine start voltage.

·

The navigation receiver assembly*1 or radio and display receiver assembly*2 is the master unit.



WIRING DIAGRAM

U170710E02
5.375,3.188 5.75,3.354 0.375,0.167 10 false W14 5.25,0.333 5.448,0.5 0.198,0.167 10 false 1 5.25,0.896 5.417,1.063 0.167,0.167 10 false 2 2.51,2.76 2.958,2.927 0.448,0.167 10 false H57*1 2.938,1.177 3.385,1.344 0.448,0.167 10 false ACC 2.771,0.615 3.573,0.781 0.802,0.167 10 false RAD NO.3 3.729,1.646 3.927,1.813 0.198,0.167 10 false 9 3.729,2.115 4.125,2.281 0.396,0.167 10 false 10 5.25,2.125 5.448,2.292 0.198,0.167 10 false 4 5.25,1.635 5.448,1.802 0.198,0.167 10 false 3 5.5,2.698 5.875,2.865 0.375,0.167 10 false GND 3.354,2.229 3.625,2.396 0.271,0.167 10 false TX- 3.344,1.75 3.625,1.917 0.281,0.167 10 false TX+ 5.5,2.219 5.875,2.385 0.375,0.167 10 false TX1- 5.5,1.75 5.875,1.917 0.375,0.167 10 false TX1+ 5.5,0.99 5.875,1.156 0.375,0.167 10 false ACC 5.5,0.469 5.938,0.635 0.438,0.167 10 false +B 5.177,2.604 5.375,2.771 0.198,0.167 10 false 17 2.51,2.927 3.802,3.323 1.292,0.396 10 false Navigation Receiver Assembly*1 2.51,3.542 2.958,3.708 0.448,0.167 10 false H52*2 0.115,2.938 2.292,3.448 2.177,0.51 10 false *1: w/ Navigation System (for Navigation Receiver Type) 0.115,3.698 2.208,4.448 2.094,0.75 10 false *2: w/ Navigation System (for Radio and Display Type) or w/o Navigation System 2.51,3.74 3.906,4.135 1.396,0.396 10 false Radio and Display Receiver Assembly*2 5.375,3.385 6.573,3.781 1.198,0.396 10 false Television Display Assembly 0.302,1.01 1.458,1.208 1.156,0.198 10 false from ACC Relay 0.552,0.448 1.708,0.646 1.156,0.198 10 false from Battery

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses and relays for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK FOR DTC

OK

NG

2.CHECK CONNECTOR CONNECTION CONDITION
2.CHECK CONNECTOR CONNECTION CONDITION
a.

Check that the television display assembly and navigation receiver assembly*1 or radio and display receiver assembly*2 connectors are connected properly.

*1: w/ Navigation System (for Navigation System)

*2: w/ Navigation System (for Radio and Display Type) or w/o Navigation System


OK:

The connectors are connected properly.




OK

3.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - BATTERY AND BODY GROUND)

NG

CONNECT CONNECTOR CORRECTLY

3.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - BATTERY AND BODY GROUND)
a.
U149261E03
1.281,1.292 1.531,1.729 1.531,1.729 1.771,1.729 true 1.052,1.125 0.823,0.573 0.823,0.573 0.604,0.573 true 1.156,1.146 1.406,0.438 1.406,0.438 1.625,0.438 true 0.198,0.094 0.354,0.271 0.156,0.177 10 false *a 1.802,1.625 2.125,1.802 0.323,0.177 10 false GND 0.365,0.479 0.552,0.656 0.188,0.177 10 false +B 1.667,0.344 2.24,0.521 0.573,0.177 10 false ACC 0.313,1.104 0.667,1.281 0.354,0.177 10 false W14

Disconnect the television display assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
W14-17 (GND) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
W14-1 (+B) - Body ground Always 11 to 14 V
W14-2 (ACC) - Body ground Ignition switch ACC 11 to 14 V



Text in Illustration
*a Front view of wire harness connector
(to Television Display Assembly)


OK

4.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY OR RADIO AND DISPLAY RECEIVER ASSEMBLY- TELEVISION DISPLAY ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY OR RADIO AND DISPLAY RECEIVER ASSEMBLY- TELEVISION DISPLAY ASSEMBLY)
a.

w/ Navigation System (for Navigation System)

i.

Disconnect the H57 navigation receiver assembly connector.



b.

w/ Navigation System (for Radio and Display Type) or w/o Navigation System

i.

Disconnect the H52 radio and display receiver assembly connector.



c.

Disconnect the W14 television display assembly connector.


d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
w/ Navigation System (for Navigation System):
Tester Connection Condition Specified Condition
H57-9 (TX+) - W14-3 (TX1+) Always Below 1 Ω
H57-10 (TX-) - W14-4 (TX1-) Always Below 1 Ω
H57-9 (TX+) - Body ground Always 10 kΩ or higher
H57-10 (TX-) - Body ground Always 10 kΩ or higher

w/ Navigation System (for Radio and Display Type) or w/o Navigation System:
Tester Connection Condition Specified Condition
H52-9 (TX+) - W14-3 (TX1+) Always Below 1 Ω
H52-10 (TX-) - W14-4 (TX1-) Always Below 1 Ω
H52-9 (TX+) - Body ground Always 10 kΩ or higher
H52-10 (TX-) - Body ground Always 10 kΩ or higher




OK

5.CHECK TELEVISION DISPLAY ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5.CHECK TELEVISION DISPLAY ASSEMBLY
a.

Temporarily replace the television display assembly with a new or known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>TELEVISION DISPLAY>REMOVAL).



c.

Check for DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>REAR SEAT ENTERTAINMENT SYSTEM>DTC CHECK / CLEAR).

OK:

DTC B15D5 is not output.


Result
Result Proceed to
OK A
NG (w/ Navigation System [for Navigation System]) B
NG (w/ Navigation System [for Radio and Display Type] or w/o Navigation System) C



A

END (TELEVISION DISPLAY ASSEMBLY WAS DEFECTIVE)

B

C