Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE WARNING ECU (for LHD) › 2015.06–2020.08
RM27T0E _56 Audio / Visual / Telematics _053722 PARK ASSIST / MONITORING _0260993 CLEARANCE WARNING ECU(for LHD) A

PARK ASSIST / MONITORING  CLEARANCE WARNING ECU(for LHD)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 89340A 1.INSTALL CLEARANCE WARNING ECU ASSEMBLY (for 4 Sensor Type)

a.

Install the clearance warning ECU assembly with the bolt.


b.

Connect the connector.


Hide 89340A 2.INSTALL CLEARANCE WARNING ECU ASSEMBLY (for 8 Sensor Type)

a.

Install the clearance warning ECU assembly with the 2 nuts.


b.

Connect the connector.


Hide 55550 3.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 55607 4.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55461A 5.INSTALL INSTRUMENT PANEL ORNAMENT

Hide 55317A 6.INSTALL INSTRUMENT SIDE PANEL RH

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).