The video signal from the rear television camera assembly is transmitted to the navigation receiver assembly*1 or radio and display receiver assembly*2.
*1: for Navigation Receiver Type
*2: for Radio and Display Type
If the cable was disconnected from and reconnected to the negative (-) battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point" (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU)>INITIALIZATION).
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU)>CALIBRATION).
Images may be unclear even in normal conditions if:
Electrical devices are used in the cabin (noise may occur in the image).
Accessories that generate radio waves have been installed (noise may occur in the image).
The outer mirror switch assembly is operated (noise may occur in the image).
The navigation receiver assembly*1 or radio and display receiver assembly*2 is cold (the image immediately after turning the engine switch on (IG) may be blurred or darker than normal).
*1: for Navigation Receiver Type
*2: for Radio and Display Type
The camera lens is dirty with snow, mud, etc.
A strong beam of light, such as a sunbeam or headlight, hits the camera.
It is too dark around the camera (at night etc.).
The ambient temperature around the camera is either too high or too low.
The vehicle is tilted at a steep angle.
The rear television camera assembly lens is scratched.
The rear television camera assembly lens has drops of water on it or the humidity is high.
When the camera is used under fluorescent lights, sodium lights, or mercury lights etc., the lights and the illuminated area may appear to flicker.
Check the vehicle type.
| Result | Proceed to |
|---|---|
| for Navigation Receiver Type | A |
| for Radio and Display Type | B |
A
B
Disconnect the v3*1 or X10*2 rear television camera assembly connector.
*1: w/ Tire Carrier
*2: w/o Tire Carrier
Disconnect the H55 navigation receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| v3-6 (CB+) - H55-11 (CA+) | Always | Below 1 Ω |
| v3-3 (CV+) - H55-12 (V+) | Always | Below 1 Ω |
| v3-2 (CV-) - H55-24 (V-) | Always | Below 1 Ω |
| v3-5 (CGND) - H55-23 (CGND) | Always | Below 1 Ω |
| v3-6 (CB+) or H55-11 (CA+) - Body ground | Always | 10 kΩ or higher |
| v3-3 (CV+) or H55-12 (V+) - Body ground | Always | 10 kΩ or higher |
| v3-2 (CV-) or H55-24 (V-) - Body ground | Always | 10 kΩ or higher |
| v3-5 (CGND) or H55-23 (CGND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| X10-6 (CB+) - H55-11 (CA+) | Always | Below 1 Ω |
| X10-3 (CV+) - H55-12 (V+) | Always | Below 1 Ω |
| X10-2 (CV-) - H55-24 (V-) | Always | Below 1 Ω |
| X10-5 (CGND) - H55-23 (CGND) | Always | Below 1 Ω |
| X10-6 (CB+) or H55-11 (CA+) - Body ground | Always | 10 kΩ or higher |
| X10-3 (CV+) or H55-12 (V+) - Body ground | Always | 10 kΩ or higher |
| X10-2 (CV-) or H55-24 (V-) - Body ground | Always | 10 kΩ or higher |
| X10-5 (CGND) or H55-23 (CGND) - Body ground | Always | Below 1 Ω |
OK
NG
Replace the rear television camera assembly with a new or known good one.
Check that the parking assist monitor system operates normally.
Parking assist monitor system operates normally.
OK
NG
Disconnect the v3*1 or X10*2 rear television camera assembly connector.
*1: w/ Tire Carrier
*2: w/o Tire Carrier
Disconnect the H50 radio and display receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| v3-6 (CB+) - H50-11 (CA+) | Always | Below 1 Ω |
| v3-3 (CV+) - H50-12 (V+) | Always | Below 1 Ω |
| v3-2 (CV-) - H50-24 (V-) | Always | Below 1 Ω |
| v3-5 (CGND) - H50-23 (CGND) | Always | Below 1 Ω |
| v3-6 (CB+) or H50-11 (CA+) - Body ground | Always | 10 kΩ or higher |
| v3-3 (CV+) or H50-12 (V+) - Body ground | Always | 10 kΩ or higher |
| v3-2 (CV-) or H50-24 (V-) - Body ground | Always | 10 kΩ or higher |
| v3-5 (CGND) or H50-23 (CGND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| X10-6 (CB+) - H50-11 (CA+) | Always | Below 1 Ω |
| X10-3 (CV+) - H50-12 (V+) | Always | Below 1 Ω |
| X10-2 (CV-) - H50-24 (V-) | Always | Below 1 Ω |
| X10-5 (CGND) - H50-23 (CGND) | Always | Below 1 Ω |
| X10-6 (CB+) or H50-11 (CA+) - Body ground | Always | 10 kΩ or higher |
| X10-3 (CV+) or H50-12 (V+) - Body ground | Always | 10 kΩ or higher |
| X10-2 (CV-) or H50-24 (V-) - Body ground | Always | 10 kΩ or higher |
| X10-5 (CGND) or H50-23 (CGND) - Body ground | Always | Below 1 Ω |
OK
NG
Replace the rear television camera assembly with a new or known good one.
Check that the parking assist monitor system operates normally.
Parking assist monitor system operates normally.
OK
NG
(See pageAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL)