Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY › 2015.06–2020.08
RM27T0E _58 Vehicle Interior _053735 SUPPLEMENTAL RESTRAINT SYSTEMS _0261095 KNEE AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 73900 1.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B238328

Connect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



d.

Install the airbag assembly with the 4 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 55045 2.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

Hide 55480D 3.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Hide 55471A 4.INSTALL INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)

Hide 55476C 5.INSTALL INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)

Hide 55318C 6.INSTALL INSTRUMENT SIDE PANEL LH (for LHD)

Hide 55317A 7.INSTALL INSTRUMENT SIDE PANEL RH (for RHD)

Hide 55606 8.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 62111C 10.INSTALL COWL SIDE TRIM BOARD RH (for RHD)

Hide 67920 11.INSTALL DOOR SCUFF PLATE ASSEMBLY LH (for LHD)

Hide 67910 12.INSTALL DOOR SCUFF PLATE ASSEMBLY RH (for RHD)

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 14.CHECK SRS WARNING LIGHT