Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › REAR AIRBAG SENSOR (for 3 Door) › 2015.06–2020.08
RM27T0E _58 Vehicle Interior _053735 SUPPLEMENTAL RESTRAINT SYSTEMS _0261099 REAR AIRBAG SENSOR(for 3 Door) A

SUPPLEMENTAL RESTRAINT SYSTEMS  REAR AIRBAG SENSOR(for 3 Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 89834 1.INSTALL REAR AIRBAG SENSOR LH

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Install the rear airbag sensor with the nut.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:
·

If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

·

When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.




d.

Check that the rear airbag sensor is not loose.


e.

Connect the connector.


Hide 64712F 4.INSTALL FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)

Hide 64937A 5.INSTALL NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)

Hide 64725D 6.INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

Hide 64910M 11.INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

Hide 62312B 12.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Hide 14.INSTALL REAR NO. 1 SEAT ASSEMBLY

a.

for 60/40 Split Double-folding Seat Type LH Side:



b.

for 60/40 Split Double-folding Seat Type RH Side:



c.

for 60/40 Split Tumble Seat Type LH Side:



d.

for 60/40 Split Tumble Seat Type RH Side:



e.

for 60/40 Split Slide Walk-in Seat Type LH Side:



f.

for 60/40 Split Slide Walk-in Seat Type RH Side:



Hide 15.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

CAUTION:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 16.CHECK SRS WARNING LIGHT