Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
2.REMOVE REAR NO. 1 SEAT ASSEMBLY
for 60/40 Split Double-folding Seat Type LH Side:
Remove the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Double-folding Seat Type LH Side)>REMOVAL).
for 60/40 Split Double-folding Seat Type RH Side:
Remove the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Double-folding Seat Type RH Side)>REMOVAL).
for 60/40 Split Tumble Seat Type LH Side:
Remove the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY(for 60/40 Split Tumble Seat Type LH Side)>REMOVAL).
for 60/40 Split Tumble Seat Type RH Side:
Remove the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY(for 60/40 Split Tumble Seat Type RH Side)>REMOVAL).
for 60/40 Split Slide Walk-in Seat Type LH Side:
Remove the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type LH Side)>REMOVAL).
for 60/40 Split Slide Walk-in Seat Type RH Side:
Remove the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type RH Side)>REMOVAL).
67920
3.REMOVE DOOR SCUFF PLATE ASSEMBLY LH
62312B
4.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
64910M
5.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
58649C
6.REMOVE MAT SET PLATE COVER
58574A
7.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE
62538E
8.REMOVE QUARTER TRIM COVER HOLE LH
58570C
9.REMOVE REAR FLOOR CARPET ASSEMBLY
64725D
10.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
64937C
11.REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)
64712F
12.REMOVE FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)
73233A
13.REMOVE OUTER LAP BELT COVER
64740C
14.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
89834
15.REMOVE REAR AIRBAG SENSOR LH
Remove the nut and rear airbag sensor.
Disconnect the connector.