Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR NO. 2 SEAT ASSEMBLY LH
for Manual Seat Type:
Remove the rear No. 2 seat assembly LH (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Manual Seat Type LH Side)>REMOVAL).
for Power Seat Type:
Remove the rear No. 2 seat assembly LH (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Power Seat Type LH Side)>REMOVAL).
58371F
2.REMOVE REAR NO. 1 FLOOR STEP COVER
67934
3.REMOVE QUARTER SCUFF PLATE LH
67918D
4.REMOVE REAR DOOR SCUFF PLATE LH
62332C
5.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
Partially remove the rear door opening trim weatherstrip so that the front quarter trim panel assembly LH and deck trim side panel assembly LH can be removed (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL).
57412C
6.REMOVE FLOOR SIDE RAIL LH (w/ Deck Rail)
57411D
7.REMOVE FLOOR SIDE RAIL RH (w/ Deck Rail)
73233A
8.REMOVE REAR NO. 1 SEAT OUTER LAP BELT ANCHOR COVER
64725D
9.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
64937A
10.REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)
64712F
11.REMOVE FRONT DECK SIDE TRIM COVER LH (w/ Tonneau Cover)
74617A
12.REMOVE ASSIST GRIP PLUG
74603C
13.REMOVE ASSIST GRIP SUB-ASSEMBLY
64740C
14.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.
Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor.
for RH Side:
Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor.
Detach the 4 clips and 8 claws and remove the deck trim side panel.
62640P
15.REMOVE REAR QUARTER TRIM PANEL ASSEMBLY LH
73570
16.REMOVE REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH
Remove the bolt and rear No. 1 seat outer belt shoulder anchor.
Remove the bolt and rear No. 2 seat outer belt assembly.
73608
17.REMOVE REAR SEAT OUTER BELT ANCHOR PLATE SUB-ASSEMBLY LH
Remove the bolt and anchor plate.
73090A
18.REMOVE SEAT BELT ANCHOR PLATE ASSEMBLY (for RH Side)
Remove the 2 bolts and anchor plate.