1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
2.REMOVE REAR NO. 2 SEAT ASSEMBLY
for Manual Seat:
Remove the rear No. 2 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Manual Seat Type LH Side)>REMOVAL).
for Power Seat:
Remove the rear No. 2 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Power Seat Type LH Side)>REMOVAL).
for Face to Face Seat Type:
Remove the rear No. 2 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(for Face to Face Seat Type)>REMOVAL).
3.REMOVE REAR NO. 1 SEATBACK ASSEMBLY
for 60/40 Split Double-folding Seat Type LH Side:
Remove the rear No. 1 seatback assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Double-folding Seat Type LH Side)>REMOVAL).
for 60/40 Split Double-folding Seat Type LH Side:
Remove the rear No. 1 seatback assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Double-folding Seat Type RH Side)>REMOVAL).
58371F
4.REMOVE REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)
67933
5.REMOVE QUARTER SCUFF PLATE RH (w/ Rear No. 2 Seat)
67917C
6.REMOVE REAR DOOR SCUFF PLATE RH
62331C
7.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
73233
8.REMOVE OUTER LAP BELT ANCHOR COVER
64910M
9.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
64717A
10.REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (w/o Rear No. 2 Seat)
58401A
11.REMOVE NO. 1 DECK BOARD SUB-ASSEMBLY (w/o Rear No. 2 Seat)
58574A
12.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE (w/o Rear No. 2 Seat)
57412C
13.REMOVE FLOOR SIDE RAIL LH (w/ Deck Rail)
57411D
14.REMOVE FLOOR SIDE RAIL RH (w/ Deck Rail)
58570C
15.REMOVE REAR FLOOR CARPET ASSEMBLY (w/o Rear No. 2 Seat)
73233A
16.REMOVE REAR NO. 1 LAP BELT OUTER ANCHOR COVER SEAT
64725D
17.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
64937A
18.REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)
64712F
19.REMOVE FRONT DECK SIDE TRIM COVER RH (w/ Tonneau Cover)
74617A
20.REMOVE ASSIST GRIP PLUG (w/ Rear No. 2 Seat)
74603C
21.REMOVE ASSIST GRIP SUB-ASSEMBLY (w/ Rear No. 2 Seat)
64730B
22.REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
62630P
23.REMOVE REAR QUARTER TRIM PANEL ASSEMBLY RH
24.REMOVE HEATER BRACKET
Disconnect the 2 connectors.
Detach the clamp and remove the 3 screws and heater bracket.
87103D
25.REMOVE REAR BLOWER WITH FAN MOTOR SUB-ASSEMBLY
Remove the 3 screws and rear blower with fan motor.