53292A
1.REMOVE UPPER RADIATOR SUPPORT SEAL
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
51405A
4.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
5.DRAIN ENGINE COOLANT
16470
6.REMOVE RADIATOR RESERVOIR
Disconnect the No. 1 water by-pass hose and detach the 2 clamps from the fan shroud.
Disconnect the No. 2 water by-pass hose from the radiator reservoir.
Remove the 3 bolts and radiator reservoir.
74481
7.REMOVE BATTERY HOLD DOWN CLAMP
28800
8.REMOVE BATTERY
74431
9.REMOVE BATTERY TRAY
17881
10.REMOVE NO. 1 AIR CLEANER HOSE
17705
11.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
17801
12.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
13.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
16361A
14.REMOVE FAN AND GENERATOR V BELT
17275A
15.REMOVE COMPRESSOR OUTLET ELBOW
87120G
16.REMOVE VISCOUS WITH MAGNET CLUTCH HEATER ASSEMBLY (for Cold Area Specification Vehicles)
87101
17.REMOVE NO. 1 VISCOUS HEATER BRACKET SUB-ASSEMBLY (for Cold Area Specification Vehicles)
88711
18.REMOVE NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
Remove the bolt and disconnect the discharge hose from the cooler compressor.
| *A | except Model Code KDJ150L-GKFEYV, KDJ150L-GKAEYV for LHD |
| *B | Model Code KDJ150L-GKFEYV, KDJ150L-GKAEYV |
| *C | for Cold Area Specification Vehicles |
Remove the O-ring from the discharge hose.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
88712
19.REMOVE NO. 1 COOLER REFRIGERANT SUCTION HOSE
Remove the bolt and disconnect the suction hose.
| *A | except Model Code KDJ150L-GKFEYV, KDJ150L-GKAEYV for LHD |
| *B | Model Code KDJ150L-GKFEYV, KDJ150L-GKAEYV |
| *C | for Cold Area Specification Vehicles |
Remove the O-ring from the suction hose.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
88320
20.REMOVE COOLER COMPRESSOR ASSEMBLY
Disconnect the connector.
Remove the 4 bolts and cooler compressor.
| *A | except Cold Area Specification Vehicles |
| *B | for Cold Area Specification Vehicles |