53292A
1.REMOVE UPPER RADIATOR SUPPORT SEAL
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
51405A
3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
4.DRAIN ENGINE COOLANT
16470
5.REMOVE RADIATOR RESERVOIR
Disconnect the No. 1 water by-pass hose and detach the 2 clamps from the fan shroud.
Disconnect the No. 2 water by-pass hose from the radiator reservoir.
Remove the 3 bolts and radiator reservoir.
74481
6.REMOVE BATTERY HOLD DOWN CLAMP
28800
7.REMOVE BATTERY
74431
8.REMOVE BATTERY TRAY
17881
9.REMOVE NO. 1 AIR CLEANER HOSE
17705
10.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
17801
11.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
12.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
17275A
13.REMOVE COMPRESSOR OUTLET ELBOW
16361A
14.REMOVE FAN AND GENERATOR V BELT
Remove the 2 bolts and front heater bracket.
Remove the fan and generator V belt (See page Engine / Hybrid System>1KD-FTV (ENGINE MECHANICAL)>DRIVE BELT>REMOVAL).
87120G
15.REMOVE VISCOUS WITH MAGNET CLUTCH HEATER ASSEMBLY
Disconnect the viscous heater connector.
Using pliers, grip the claws of the clips and slide the 2 clips.
Disconnect the water by-pass hose and water hose.
Remove the 2 bolts and heater assembly.
87101
16.REMOVE NO. 1 VISCOUS HEATER BRACKET SUB-ASSEMBLY