Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
84453
1.INSTALL IDLE UP SWITCH (for LHD)
Attach the 2 claws to install the switch.
84453
2.INSTALL IDLE UP SWITCH (for RHD)
Attach the 2 claws to install the switch.
87290
3.INSTALL HEATER SWITCH ASSEMBLY (for LHD)
Attach the 2 claws to install the switch.
87290
4.INSTALL HEATER SWITCH ASSEMBLY (for RHD)
Attach the 2 claws to install the switch.
55045
5.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
55480D
6.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
55476C
7.INSTALL INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)
55471A
8.INSTALL INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)
55318C
9.INSTALL INSTRUMENT SIDE PANEL LH
55606
10.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
62112
11.INSTALL COWL SIDE TRIM BOARD LH
67920
12.INSTALL DOOR SCUFF PLATE ASSEMBLY LH