Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM27T0E _59 Vehicle Exterior _053742 WINDOW / GLASS _0261225 POWER WINDOW CONTROL SYSTEM C

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  B2313  Glass Position Initialization Incomplete  


DESCRIPTION

The power window regulator motor is driven by operating the power window switch. The power window regulator motor assembly has a motor, regulator and ECU.

When the ECU determines that the power window regulator motor has not been initialized, DTC B2313 is stored.

HINT:

This DTC may be stored for all the windows.


NOTICE:
·

When a power window regulator motor is reinstalled or replaced, the power window control system must be initialized.

·

After any door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be resumed by repeating the following operation at least 5 times:

(a)

Close the power window by fully pulling up the power window switch and holding it in the auto up position.

(b)

Open the power window by fully pushing down the power window switch.




D-Door Motor
DTC Code DTC Detection Condition Trouble Area
B2313 Either condition is met:
·

Power window regulator motor is not initialized.

·

Power window regulator motor malfunctions.


·

Front power window regulator motor LH*1

·

Front power window regulator motor RH*2



*1: for LHD

*2: for RHD


P-Door Motor
DTC Code DTC Detection Condition Trouble Area
B2313 Either condition is met:
·

Power window regulator motor is not initialized.

·

Power window regulator motor malfunctions.


·

Front power window regulator motor RH*1

·

Front power window regulator motor LH*2



*1: for LHD

*2: for RHD


RL-Door Motor (for 5 Door)
DTC Code DTC Detection Condition Trouble Area
B2313 Either condition is met:
·

Power window regulator motor is not initialized.

·

Power window regulator motor malfunctions.


Rear power window regulator motor LH

RR-Door Motor (for 5 Door)
DTC Code DTC Detection Condition Trouble Area
B2313 Either condition is met:
·

Power window regulator motor is not initialized.

·

Power window regulator motor malfunctions.


Rear power window regulator motor RH

PROCEDURE

1.PERFORM INITIALIZATION (APPLICABLE LOCATION)
a.

Initialize the power window regulator motor (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).



NEXT

2.CHECK DTC
2.CHECK DTC
a.

Check for DTCs (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DTC CHECK / CLEAR).

OK:

DTC B2313 is not output


Result
Result Proceed to
No DTCs output A
DTC output (Front power window LH) B
DTC output (Front power window RH) C
DTC output (Rear power window LH)* D
DTC output (Rear power window RH)* E

*: for 5 Door




A

END (POWER WINDOW CONTROL SYSTEM WAS NOT INITIALIZED)

B

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

C

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

D

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

E

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH