Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR (for Rear Door) › 2015.06–2020.08
RM27T0E _59 Vehicle Exterior _053742 WINDOW / GLASS _0261233 POWER WINDOW REGULATOR MOTOR(for Rear Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Rear Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 85710E 1.INSTALL REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

a.

Apply MP grease to the sliding and rotating areas of the regulator motor.


b.

Using a T25 "TORX" socket wrench, install the power window regulator motor with the 3 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

A new rear window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.



Hide 69840A 2.INSTALL REAR DOOR WINDOW REGULATOR ASSEMBLY LH

Hide 68104 3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 68124B 4.INSTALL REAR DOOR QUARTER WINDOW GLASS LH

Hide 67408E 5.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

Hide 68152C 6.INSTALL REAR DOOR GLASS RUN LH

Hide 67842E 7.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 68174A 9.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH

Hide 67604 10.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 74611C 11.INSTALL ASSIST GRIP COVER LH

Hide 69298C 12.INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 14.INITIALIZE POWER WINDOW CONTROL SYSTEM

a.

Initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).