A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
84160
1.INSTALL ROOM LIGHT SWITCH ASSEMBLY (for LHD)
Attach the 2 claws to install the switch.
84160
2.INSTALL ROOM LIGHT SWITCH ASSEMBLY (for RHD)
Attach the 2 claws to install the switch.
55045
3.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
55480D
4.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for LHD)
55476C
5.INSTALL INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)
55471A
6.INSTALL INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)
55318C
7.INSTALL INSTRUMENT SIDE PANEL LH
55606
8.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
62112
9.INSTALL COWL SIDE TRIM BOARD LH
67920
10.INSTALL DOOR SCUFF PLATE ASSEMBLY LH